Cabriodoc Germany | home products Technic mb r/c107 CABRIODOC Germany | Instruction Manuals contact
Convertible Fabric SoftTop Care Kit for all colors  

CABRIODOC Fabric Express Clean + Protect System

Fabric Cleaner Concentrate 50 ml / 1.7 fl oz + SoftTop Brush.
Sufficient for up-to 3 applications (2-seater)

Fabric Protectant - Proofer Concentrate 100 ml / 3.4 fl oz + Sponge.
Sufficient for up-to 3 applications (2-seater)

Cleaner + Protectant are not suitable for vinyl SoftTops!

To determine your SoftTop is made of fabric or vinyl, just make the SoftTop water test. Apply some drops of water on your SoftTop. Try to rub the water into the material. If it starts to soak in, it should be fabric. If it sits on the top and does not soak in, it should be vinyl.

Do not apply the products in direct sunlight! Processing temperature 15-30 °C (59-86 °F)!
If cleaner is stored below 20 °C / 68 °F it gets viscous and solid! Worm-up cleaner for thinness!

Do not clean partial area! Clean and protect the entire SoftTop!

Cleaning and protecting must be carried out in clean environment. Clean means without pollen, spurs or other pollutions in the air. Incapsulating these substances by the protectant can cause a fungal attack. Fungal attack is bad on health!

Do not use dirty water or rain water! Avoid to use a high-pressure cleaner!
If there is no other possibility, use it with distance of approx. 1 m (3-4 foot) or reduce pressure.


Pre-wash SoftTop with a soft jet of clear water. If possible use warm water for better cleaning results.
Apply some drobs CABRIODOC Cleaner Concentrate on the wet SoftTop. Scrub it with circular motions by using the CABRIODOC SoftTop Brush until you get white foam. Leave the cleaner on for 10-20 minutes for difficult soiled areas and repeat the treatment if necessary.

Rinse SoftTop with clean water until no remaining foam from the cleaner is observed.

Wait 10-15 minutes until water is drained off. The SoftTop should not be soaked or too dry. Apply CABRIODOC Protectant Concentrate in drobs on the humid sponge. Sponge should not be soaked and saturated with protectant. Scrub protectant trackwise from the center towards the edge. Apply additional drobs of protectant on the sponge all 2 or 3 tracks. Use protectant sparingly. Wipe off any splashes or dribbles on the paintwork or the glass with a soft cloth.

We recommand to dry SoftTop before you use the car. However it is possible to use and dry it, if you drive  slowly. But do not expose to rain or sunlight until it is fully dried.

It is also possible to apply protectant after leaving the car wash. In most cases SoftTop is still humid and ready for application of protectant.